Smr Menu Programmable Parameters - Rectifier RT9- 24V Installation, Operation And Technical Manual

Installation, Operation and Technical Manual
If SMR was shut down on "primary not OK" this screen is
not displayed.
Read SMR version and heatsink temperature after pressing
INC or DEC at previous screen.
The rest of the SMR menu consists of screens detailing the SMR operating parameters.
Float Voltage value. This parameter is globally (and
indirectly) set in the BATT menu so cannot be changed in
this screen. It is set automatically to a value equal to the
sum of the Sys Float and Sys Drop values set in the BATT
menu.
As with the Float Voltage value, the Equalisation Voltage
parameter is globally (and indirectly) set in the BATT menu
so cannot be changed in this screen. It is set automatically
to a value equal to the sum of the Sys Equal and Sys Drop
values set in the BATT menu.
If "ENTER" is pressed while viewing above 2 screens, the
following message will appear.

6.7.1 SMR Menu Programmable Parameters

The remaining screens show the SMR related operating parameters which can be
changed by pressing ENTER.
When this is done, the number flashes on and off and can then be incremented or
decremented by pressing the INC or DEC buttons respectively. When the correct value is
obtained, press ENTER to enter the number into memory.
SMR high voltage alarm level.
SMR low voltage alarm level.
SMR DC High Volts Shutdown (HVSD).
SMR Current Limit.
Fault Reset; by pressing ENTER when this screen is
displayed, any latched alarm, such as HVSD, is reset and
the unit will restart unless it is damaged or faulty.
Please note that any parameter change will apply to all the SMRs.
158-1872-01
169-3761-02
SMR V high Alarm
SMR V low Alarm
Reset SMR Fault
62
Rectifier Technologies
SMR3
HV Shut Down
SMR3
58C
SMR Float
52.3V
SMR Equalise
59.3V
SMR Float
Not Adjustable
56.3V
48.1V
SMR HVSD
62.0V
SMR I Limit
25A
Press ENTER
19-Feb-14