Packing In The Flightcase; Specifications - Martin MAC Viper Installation Manual

Packing in the flightcase

The Beam lens must be removed from the MAC Viper AirFX before the fixture is packed in the Martin™ MAC
Viper flightcase for transport. To pack the fixture in the flightcase:
1. Unclip the Beam lens from its mounting collar with reference to Figure 9 on page 5. Leave the mounting collar
installed on the fixture
2. Disconnect the Beam Kit safety wire from the Beam lens with reference to Figure 8 on page 5 and remove the
Beam lens from the fixture.
3. Pack the fixture in the flight case without the Beam lens. Store the Beam lens separately.

Specifications

The MAC Viper AirFX™ with the MAC Viper Beam Kit installed weighs 37.6 kg (82.9 lbs.). It has the dimensions
shown in millimeters below:
551
For full specifications, see the Product Support page for the MAC Viper Beam™ on www.martin.com
6
866
701
255
335
This minimum center-to-center
distance can be reduced if pan limits
are set via the control menus
Martin MAC Viper Quadray™ Module Installation and DMX Control Guide
473
785
885