Martin MAC Viper Installation Manual page 4

9. See Figure 4. Line up the Beam Kit mounting
collar over the head so that the kit's safety wire
will pass through the cutout A in the front of the
head above the safety wire attachment point and
the connector attachment wire will pass through
the cutout B in the opposite side of the head,
above the lens accessory socket C.
10. Lower the mounting collar onto the head, making
sure that it sits completely square to the head. Do
not use excessive force. You may need to rotate
the collar slightly to the left and to the right until
you can feel that it has engaged correctly. Check
that the safety wire and the connector attachment
wire are not trapped between the collar and the
head.
11. See Figure 5.
Fasten the
collar in place
by tightening
the four Torx 20
screws
(arrowed) on
the front of the
collar.
12. See Figure 6. Pass the Beam Kit's safety wire
through the hole A in the head chassis and then
into the safety wire attachment point B. Push and
slide the fastener so that it is locked into the
attachment point.
4 Martin MAC Viper Quadray™ Module Installation and DMX Control Guide
A
C
Figure 4
Figure 5
A
B
Figure 6
B