Jeep 2012 Grand Cherokee Owner's Manual page 451

Transfer Case Switch
NOTE: If shift conditions/interlocks are not met, or a
transfer case motor temperature protection condition
exists, a "For 4x4 Low Slow Below 3 MPH or 5 KPH Put
Trans in N Press 4 Low" message will flash from the
Electronic Vehicle Information Center (EVIC). Refer to
"Electronic Vehicle Information Center (EVIC)" in "Un-
derstanding Your Instrument Panel" for further informa-
tion.
4WD LOW To 4WD HI
With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h), the
ignition switch in the ON position or the engine running,
shift the transmission into NEUTRAL, and press the
"4WD LOW" button once on the transfer case switch. The
"4WD LOW" indicator light in the instrument cluster
will flash and go out when the shift is complete.
NOTE:
• If shift conditions/interlocks are not met, or a transfer
case motor temperature protection condition exists, a
"For 4x4 High Slow Below 3 MPH or 5 KPH Put Trans
in N Press 4 Low" message will flash from the
Electronic Vehicle Information Center (EVIC). Refer to
STARTING AND OPERATING 447
5