Connecting Power And Turning On The Amiga - Commodore Amiga A1200 User Manual

Connecting Power and Turning On the Amiga
Connecting Power and Turning On
the Amiga
1-13
Caution
Do not plug in and turn on the Amiga until you have
securely connected all equipment.
When all other connections have been made, you can connect your
system to power and turn it on.
1. Connect peripherals to power.
2. Plug in all peripheral equipment as described in the previous
sections.
3. Attach the Amiga power cable.
In the United States and Canada the Amiga power cable has a
square 5-pin male connector at one end, the power supply in the
middle, and a standard 3-prong male power plug on the other
end.
Note Different countries may use other power cable
designs. Be sure your Amiga matches the electrical
voltage requirements in your country.
Attach the male end to the connector labeled POWER on the
rear of the A1200. The other end of the cable may then be
inserted into a three-prong grounded AC outlet. The power
switch is on the power supply.
If in doubt about electrical hookup requirements consult your
dealer.
4. Plug in the Amiga.
5. Turn on the other equipment.
6. Turn on the Amiga