Commodore Amiga A1200 User Manual page 20

1-8 Main Unit
If you have a VCR or television set with a composite video input (an
RCAjack usually labeled
VID~O
IN) you should use the composite
output as described in the "Composite Monitors" section above. This
is simpler and produces a better picture. If your TV or VCR has
antenna inputs only, use the following procedure:
1.
Disconnect the cable or VHF antenna wire from the TV or VCR.
2. For coaxial cable: connect the end of the cable to a 75-ohm to
300-ohm adapter.
3. Connect the VHF antenna or adapter leads to the CONNECT
TO ANTENNA terminals on the switch box.
4. Connect the short twin-lead wire on the side of the switch box to
the VHF terminals on the TV or VCR.
5. Plug one end of the connector cable into the RF MODULATOR
jack on the Amiga.
6. Plug the other end of the connector cable into the COMPUTER
jack on the switch box.
Channel
select switch
I ,-
RF modulator
~jaCk
'" I
{~
300-ohm
~o ~
,(C! I';:
OR
'---~
_ _ 0----'
~ ~
m=t=
Switch box
Adapter 7S-ohm
7. Set the Channel Select switch to the left for channel 3 or to the
right for channel 4, whichever is not used in your geographical
area.
8. Select the COMPUTER switch setting on the switch box.