Remote Control Coupler Connecting And Disconnecting; Multi-Coupler System (If Equipped) - Kubota LA555 Operator's Manual

To avoid personal injury:
A Valve lock does not lock out switch operated
third-function hydraulics, which are active
when the key switch and the front hydraulic
valve main switch are ON.
BRemote Control Coupler Connecting and
Disconnecting
To avoid personal injury:
A Stop the engine and relieve pressure before
connecting or disconnecting lines.
A Do not use your hand to check for leaks.
C Relieve Hydraulic Pressure
1. Move the key switch to the "RUN" position.
A Don't start the engine.
2. Push the front hydraulic valve main switch "ON".
3. Press the activation switch A and B several times.
4. Push the front hydraulic valve main switch "OFF".
5. Turn the key switch to the "OFF" position.
C Connecting
1. Clean both couplers.
2. Remove dust plugs.
3. Insert the implement coupler to the tractor hydraulic
coupler.
4. Pull the implement coupler slightly to make sure
couplers are firmly connected.
C Disconnecting
1. Lower the implement first to the ground to release
hydraulic pressure in the hoses.
2. Clean the couplers.
3. Press the "Activation switch" a couple of times to
relieve hydraulic pressure.
Pull the hose straight from the hydraulic coupler to
release it.
4. Clean oil and dust from the coupler, and then replace
the dust plugs.
A Your local KUBOTA dealer can supply parts to adapt
couplers to hydraulic hoses.
OPERATING THE LOADER

MULTI-COUPLER SYSTEM (if equipped)

This system is designed to easily connect and disconnect
the 2, 4 or 8 hydraulic hoses simultaneously without oil
leak when attaching and detaching the loader.
B How to use 2P-Multi-Coupler
C Connecting
1. Open the dust cover of the fixed part.
2. Push the safety lock button and turn up the lever until
it stops.
(1) Dust Cover
(2) Safety Lock Button
(3) Lever
(4) Fixed part
3. Put the mobile part on the fixed part and engage the
reference pins in the proper holes.
(1) Mobile part
(2) Reference pins
19