Switching Your Tomtom Bandit On And Off - TomTom Bandit Quick Start Manual

Version - the software version number of your TomTom Bandit. You may need this information

if you contact Customer Support.
Serial number - The serial number of your TomTom Bandit.


Switching your TomTom Bandit on and off

Your TomTom Bandit can be on, off, or in standby. You can only switch the TomTom Bandit on and
off using the buttons on the TomTom Bandit.
Switching on your TomTom Bandit
Press the START button at the back of the TomTom Bandit for 2 seconds to switch your TomTom
Bandit on. The TomTom logo is shown, and the red LEDs flash and you hear the start-up sound. If no
microSD card is inserted into the Batt-Stick, you are asked to
TomTom Bandit can switch on.
If the TomTom Bandit is in standby mode, press the control button to wake up the TomTom Bandit.
The TomTom Bandit stays on during the following conditions:
The TomTom Bandit is recording a video or you are taking photos.

You are using the screen to set-up the TomTom Bandit.

You are operating the TomTom Bandit from your mobile phone using Wi-Fi or Bluetooth.

Switching off your TomTom Bandit
Press the STOP button at the front of the TomTom Bandit for 2 seconds to switch it off. The red
LEDs flash and you hear the shut-down sound.
The TomTom Bandit will automatically shut down if the battery power becomes too low.
Standby
To save power the TomTom Bandit automatically switches to standby after a few minutes if it's not
being used.
You can wake up the TomTom Bandit by pressing the control button, using the
using the Mobile app. If you press the START button, the TomTom Bandit will start recording or
taking photos, depending on the mode you have set.
insert a memory card
28
so that the
remote control, or