Weight Stack Label And Lubrication Instructions - TuffStuff SXT-550 Owner's Manual

Note:
1� Top plate label goes on hole off center as shown� Label will cover hole on center�

Weight stack label and lubrication instructions

1� Wipe front surface of weight stack with rubbing alcohol and wipe dry�
2� Peel off back sheet (adhesive side) from label (#167) and make sure that the label remains
attached to the application tape�
3� Line up left edge of label sheet with outside edge of weight holes�
4� Line up the first label to hole on top plate�
5� Make sure label is straight and slowly press into place�
6� Gently remove application tape and rub each label firmly against the weight stack�
7� Allow labels to stand for 2 days to allow adhesive to cure fully�
8� Open the lube package provided and apply a thin film of lubricant around the first 3 inches
of the guide rods above the top plate�
9� After the cables are installed, do a set of reps to spread the lubricant thoroughly�
SXT-550 Deluxe Hybrid Trainer
167
www.tuffstuffitness.com
21