OXTS RT-XLAN User Manual page 17

RT-XLAN User Manual
Once the panel is undone, the back of the WLAN unit can be seen. This is shown in
Figure 10. Remove the power jack plug. Cover the jack plug with insulation tape so
that it does not short against anything internally. Secure the jack plug with tape so that
it cannot flap about inside the RT-Range Hunter. The internal wireless LAN is now
disabled.
Figure 10. Disconnecting the power jack
Note that it is not necessary to use the RT-Range Target in some applications. The
RT-Range Target contains a wireless LAN and an Ethernet switch and the serial
output/input connections. If the Ethernet switch or serial connections are not needed, or
if another switch is available, then the RT-XLAN can be used without the RT-Range
Target.
Revision: 140611
17