Configuration - OXTS RT-XLAN User Manual

RT-XLAN User Manual

Configuration

There are no user configuration options on the RT-XLAN. However, it is important to
make sure that each unit is compatible with the other units in the environment. There
are several items to consider.

Each RT-XLAN will have a label showing its configuration.

The RT-XLAN labelled "Base" should be used on the Hunter vehicle.

The RT-XLAN labelled "Client" should be used on the Target vehicle.

There cannot be two RT-XLAN base units in the same environment.

There must be one RT-XLAN base unit. The RT-XLAN client units will not
communicate with each other unless there is a base present.

Each RT-XLAN has an IP address. All the units being used must have different
IP addresses. Normally the IP address will be in the range from 195.0.0.170 to
195.0.0.175. It is possible to order different IP addresses from OxTS. This IP
address range should not conflict with the recommended IP addresses with other
OxTS equipment.

The RT-XLAN will be configured for use in a specific country. Different
licensing laws require different frequencies to be used in different countries. RT-
XLAN units from one country cannot be used automatically with RT-XLAN
units from another country.
It is possible to change the configuration in the field but it is necessary to contact OxTS
support for information on how to do this. If any configuration is changed then make
sure the stickers on the outside of the RT-XLAN are changed to reflect the
configuration changes made.
Revision: 140611
11