gledhill BoilerMate HP-DEM-A User Instructions page 9

BoilerMate-HP-DEM
Mode Normal
Normal operating display
BoilerMate-HP-DEM
Mode Switch
Switch operating display
BoilerMate-HP-DEM
Mode Normal
Fault condition display
Normal Operating Display Window
In normal automatic operation the display
will be as shown opposite.
Switch Operating Display Window
If a fault occurs with the heat pump, the
'Switch' emergency electric back-up system
can be selected by pressing and holding
the 'Switch' button below the display for
at least 5 seconds. The word 'Normal' will
change to 'Switch' and fl ash.
Once the problem has been resolved,
the appliance can be returned to normal
operation by pressing the 'Switch' button
for at least 5 seconds.
Fault Condition Display Window
If a fault occurs with the BoilerMate
appliance the window will automatically
Fault 10
display the fault condition. The fault
indication will fl ash to draw your attention.
Please give this code to an Approved
Ecodan Installer (AEI). They will have the
ability to decode this and ensure the
correct parts are obtained prior to a service
call out.
Page 9