Adjusting The Dryer's Electronics For Very Soft Water - Miele T 7644 C Operating Instructions Manual

Adjusting the dryer's
electronics for very soft water
,
In some areas of the UK, water is
extremely soft which can affect the
sensitivity of the control electronics.
If the dryer is installed in an area of
very soft water, you should contact
your local water supplier for informa-
tion and advice regarding water
hardness and water conductivity. If
the water conductivity is less than
150 µS, the following programmable
function will need to be activated.
Important. This programmable
function should not be activated if,
despite the water being extremely
soft (as would be the case if a water
softener were used), its conductivity
is greater than 150 µS.
Follow the steps (A,B,C ...) to pro-
gramme and store in memory.
Before you begin, ensure that:
– The tumble dryer is switched off.
– The door is closed.
A Press the Start/Stop button and keep
it pressed in whilst carrying out steps
B-C.
B Switch the dryer on.
Wait until the Start/Stop button lights up
constantly . . .
C . . . and then release the Start/Stop
button.
D Press the Low temperature button
ten times.
Programmable functions
– The Low temperature indicator light
will flash on and off slowly once and
then on and off quickly twice.
A number to show which option is
selected will appear in the display al-
ternating with the letter P.
0 Factory default setting
I Adjusted for very soft water
(the Automatic indicator light will also
flash)
E Pressing the Start/Stop button swit-
ches between the options.
F Switch the dryer off.
The setting you have selected is now
stored in memory. You can change it
again at any time.
To check the setting:
^ Carry out steps A to D.
^ Switch the dryer off after step D.
57