Adjusting The Dryer's Electronics For Very Soft Water - Miele T 8826 WP Operating Instructions Manual

Adjusting the dryer's
electronics for very soft water
,
In some areas of the UK, water is
extremely soft which can affect the
sensitivity of the control electronics.
If the dryer is installed in an area of
very soft water, you should contact
your local water supplier for
information and advice regarding
water hardness and water
conductivity. If the water
conductivity is less than 150 µS, the
following programmable function will
need to be activated.
Important. This programmable function
should not be activated if, despite the
water being extremely soft (as would be
the case if a water softener were used),
its conductivity is greater than 150 µS.
Follow steps (A,B,C ...) to
programme and store in memory.
Before you begin, ensure that:
– The tumble dryer is switched off.
– The door is closed.
A Press the Start/Stop button and keep
it pressed in whilst carrying out steps
B-C.
B Switch the dryer on.
Wait until the Start/Stop button lights up
constantly . . .
C . . . and then release the Start/Stop
button.
D Press the Gentle tumble button eight
times.
Programming functions
– The Gentle tumble indicator light will
flash on and off slowly once and then
on and off quickly twice.
A number to show which option is
selected will appear in the display
alternating with the letter P.
0 Factory default setting
I Adjusted for very soft water
(the Automatic plus indicator light will
also flash)
E Pressing the Start/Stop button
switches between the options.
F Switch the dryer off.
The setting you have selected is now
stored in memory. You can change it
again at any time.
To check the setting:
^ Carry out steps A to D.
^ Switch the dryer off after step D.
61