External Condensed Water Outlet; Arranging The Drain Hose - Miele T 7644 C Operating Instructions Manual

External condensed water
outlet
General notes
When drying is in progress, condensed
water is pumped into the condensed
water container through the drain hose at
the back of the dryer. The condensed
water can also be drained off directly if
the tumble dryer is installed near a sink,
drain outlet etc. so that the condensed
water container does not have to be
emptied.
Drain hose length . . . . . . . . . . . . 1.50 m
Maximum delivery head . . . . . . . 1.50 m
Maximum drain hose length . . . . 4.00 m
,
If the on-site water drainage sys-
tem is not fitted with a non-return valve
or an appropriate air gap, one must
be fitted to prevent the risk of
back-flow. (See "Installation conditions
requiring a non-return valve").
The following optional accessories are
available:
– an extension hose
– a non-return valve kit for connection
to an external condensed water out-
let (includes an extension hose).
Maximum delivery head with non-re-
turn valve fitted: 1.00 m

Arranging the drain hose

,
Do not pull on the drain hose and
do not stretch it or allow it to become
kinked as it could get damaged.
Installation and connection
^ There will be a small amount of resi-
dual water in the drain hose. Have a
container ready to collect this.
^ Pull the hose off its connection (see
arrow).
^ Allow any residual water to run into
the container.
^ Unwind the hose and pull it carefully
out of the holders.
^ Position the hose to the right or left
hand side as necessary.
Leave the hose in the middle holder to
prevent it from becoming kinked inad-
vertently.
39