Miele T 7644 C Operating Instructions Manual

Table of Contents

Advertisement

Operating instructions
for condenser tumble dryer
T 7644 C
G
To avoid the risk of accidents
or damage to the machine
it is essential to read these
instructions before it is installed
and used for the first time.
M.-Nr. 06 737 050

Advertisement

Table of Contents
loading

Summary of Contents for Miele T 7644 C

  • Page 1 Operating instructions for condenser tumble dryer T 7644 C To avoid the risk of accidents or damage to the machine it is essential to read these instructions before it is installed and used for the first time. M.-Nr. 06 737 050...
  • Page 2: Caring For The Environment

    Ensure that any plastic wrappings, Energy saving tips bags etc. are disposed of safely and kept out of the reach of babies and To avoid unnecessarily long drying young children. Danger of suffocation! times and high consumption of energy: Rather than just throwing these –...
  • Page 3: Table Of Contents

    Warning and Safety instructions ........
  • Page 4 External drainage via a sink or gully ....... . 39...
  • Page 5: Warning And Safety Instructions

    The manufacturer cannot be increasingly available on the market. If held liable for the consequences of an using, do so at your own risk, and inadequate earthing system (e.g. follow the instructions provided on the electric shock).
  • Page 6 Repairs should only be undertaken by a Miele approved technician. Ensure current is not supplied to the machine until after maintenance or repair work has been carried out. Faulty components must only be replaced by genuine Miele original spare parts.
  • Page 7 If the water is drained externally electiricty supply when: through the drain hose instead of – it is switched off at the wall socket being collected in the condensed water and the plug is withdrawn, or container, make sure the drain hose is securely attached if you hang it in a –...
  • Page 8 Do not allow children to play on or near it or to play with its controls. Supervise – items which contain damaged its use by the elderly or infirm.
  • Page 9: Operating The Tumble Dryer

    - Delaying the start of a programme with indicator lights c Buzzer button i Door button An audible tone sounds at the end of Pressing this button will open the the programme. door even when the machine is d Check lights switched off at the mains.
  • Page 10 This – Delay start can happen with particularly fine fabrics, very small loads or if items – Duration of the Cool air and Warm air were partly dry beforehand. programmes – Programmable functions Delay start...
  • Page 11: Notes On Laundry Care

    ... Dry at low temperature dried if specified as suitable by the s ....Do not tumble dry manufacturer on the care label, as...
  • Page 12: How To Dry Correctly

    ^ Press the Door button to open the The headings numbered (A, B, C ...) show the operating sequence and can door. be used as a brief guide to using your ^ Load the laundry loosely into the machine. drum.
  • Page 13 (see "Programme duration / Estimated time remaining"). You cannot alter the drying level of the and Smoothing programmes. Select the duration for the Cool air and Warm air programmes ^ Select the programme you want.
  • Page 14 It will go out a few There is no cooling down phase at the minutes later to save energy. end of the following programmes: ^ Switch the dryer off by pressing the Woollens handcare, Smoothing.
  • Page 15: Additional Options

    – If you keep the Delay start button pressed in, the time will continue to For drying delicates and fabrics with increase up to 24^. the r symbol on the care label at a To begin delay start lower temperature. ^ Press the Start/Stop button.
  • Page 16: Programme Chart

    Cottons or linen fabrics, e.g.: table linen, bed linen, starched laundry. Note – To prevent laundry from drying out it should be rolled up until you are ready for ironing. Low temperature Also select the Low temperature option for delicate fabrics with the r symbol on the care label.
  • Page 17: Automatic Normal

    – Minimum iron items made of mixed fibres, cottons or synthetics, e.g.: trousers, jackets, shirts. Notes – Smooths out creasing caused during the spin cycle in the washing machine. – Fabrics are not completely dried in this programme. Remove garments as soon as the programme has finished and leave to finish drying at room temperature.
  • Page 18 Note Do not select the longest drying time to start with. Check the items as you are drying them to find the optimum time. You can use the Warm air programme to help remove odours from cotton clothing which has been worn but it still clean (select a duration of between 1/2 and 1 hour).
  • Page 19: Changing The Programme Sequence

    Do not touch the back of the reached and how long they have drum when adding or removing been dried for. items. The drum could be very hot - If you press the Start/Stop button danger of burning. again during the cooling down phase, Finish will light up in the ^ Add or remove items as required.
  • Page 20: Electronic System Lock

    The dryer's electronics are then locked. The indicator light for the Low The dryer can still be switched on but a temperature button will flash and a key programme cannot be started. symbol 0-§ will appear in the display.
  • Page 21: Cleaning And Care

    Empty the condensed water container after every drying programme. The Empty out container indicator light will come on if the maximum level of the condensed water container is reached. ^ Empty the container. The indicator light will go out when the ^ Replace the container in the dryer.
  • Page 22: Cleaning The Fluff Filters

    Cleaning them whilst dry Parts Department, or use a vacuum cleaner. Tip: You can also use a vacuum cleaner ^ Also clean the door seal (2) with a to remove the fluff. damp cloth. ^ Once clean, push the filter back into the door holder until it clicks into position.
  • Page 23: Cleaning Them With Water

    ^ Lock both dials. ^ Turn dial a and pull the filter by the dial out of the door opening as shown b. Do the same on the other side. ^ Rinse all the filters under hot, running water.
  • Page 24: Cleaning The Tumble Dryer

    Disconnect the machine from the mains electricity supply. ^ Clean the housing and control panel with a slightly damp cloth and a mild detergent or soapy water. ^ The drum and other stainless steel parts can be cleaned with a suitable...
  • Page 25: Cleaning The Condenser Unit

    Detergent residue, hair and fine fluff from the dryer can get through the fluff filters and block the condenser unit. Dust from the room in which the dryer is installed can also get into the condenser unit and cause a blockage.
  • Page 26: Checking The Condenser Unit

    ^ Pull the condenser unit out of its housing by the handle. Checking the condenser unit ^ Use a shower head or similar to rinse the unit out as shown. ^ Hold the condenser unit up to the light as shown.
  • Page 27: Replacing The Condenser Unit

    ^ With the handle facing upwards, push the condenser unit back into position in its housing. ^ Turn the lever down to the horizontal position, making sure that the hook on the lever clicks into the groove. When replacing the inner cover after cleaning, ensure that the rubber seal fits correctly into the groove.
  • Page 28: Problem Solving Guide

    Problem solving guide With the help of the following notes, minor faults in the performance of the machine, some of which may result from incorrect operation, can be put right without contacting the Service Department. Repair work to electrical appliances should only be carried out by a suitably qualified person in strict accordance with current local and national safety regulations.
  • Page 29 Remedy The Clean out This indicator light comes on – Cleaning the fluff filters is airways indicator to warn you that the dryer is usually all that is required. However, if the Clean out light comes on. not working efficiently.
  • Page 30: Other Problems

    Other problems Problem Possible cause Remedy The drying Please check all the possible causes and switch the dryer process goes off and then back on again. on too long or Ventilation to and from the dryer Open a door or window while even switches may be insufficient (e.g.
  • Page 31 Problem solving guide Problem Possible cause Remedy Water leaks from the – The inner cover of the – Ensure that the machine after the condenser unit has not condenser unit is condenser unit has been locked properly positioned correctly been cleaned.
  • Page 32 – Is the plug correctly inserted into the socket and switched on? – Is the door closed properly? – Has the fuse or circuit breaker tripped? The interior drum The lighting switches off Switch the dryer off and lighting does not come automatically (to save then on again.
  • Page 33: Changing The Lamp

    ^ To close the cover push it upwards You will find the interior lamp cover at the top of the drum aperture. and press it on the left and right until you hear it click into position. Ensure that it is fitted into position securely, as any moisture could cause a short circuit.
  • Page 34: After Sales Service

    After sales service Repairs Future updates (PC) In the event of any faults which you The indicator light marked PC is the cannot remedy yourself, or if the interface used by Miele service machine is under guarantee, please technicians during service work for...
  • Page 35: Installation And Connection

    Installation and connection Front view a Mains connection cable f Four height adjustable screw feet b Control panel g Air inlet and outlet vent for cooling the condenser unit c Condensed water container h External drainage options (e.g. via d Door...
  • Page 36: Rear View

    Protruding lid for holding when When moving the machine, you can hold it by the lid where it protrudes to moving the machine (see arrows) the rear of the dryer. To manoeuvre the b Air inlet vent for cooling the...
  • Page 37: Levelling The Machine

    This water can run out if the machine is tipped up when it is being moved. It is a good idea to run the Cool air programme for approximately 1 minute before moving the machine.
  • Page 38: External Condensed Water Outlet

    Drain hose length ... . 1.50 m Maximum delivery head ..1.50 m Maximum drain hose length .
  • Page 39: External Drainage Via A Sink Or Gully

    Otherwise water could leak out of the dryer and cause damage. A non-return valve is required: – If the tumble dryer is connected to a sink drain outlet (see the following section). – If the tumble dryer is to be...
  • Page 40 Installation and connection ^ Fit adapter 1 to the sink drain outlet using nut 2. If this nut has a flat disc in it you should take the disc out first. ^ Attach the end of the hose 4 to adapter 1.
  • Page 41: Electrical Connection

    The regulations (BS 7671 in the UK).
  • Page 42: Consumption Data

    All data without a "star" against it was calculated using EN 61121:2000. Before testing in accordance with EN 61121, dry a 3 kg load of cotton laundry with 70% residual moisture as per the above standard using the Cottons Normal programme without selecting any additional options.
  • Page 43: Technical Data

    Height 850 mm Width 595 mm Depth 634 mm Depth with door open 1074 mm Suitable for pushing under a worktop Suitable for stacking Weight 52 kg Drum volume 111 litres Maximum capacity 6 kg dry weight Capacity of condensed water container approx.
  • Page 44 Programmable functions for changing default settings The programmable functions are used to alter the machine's electronics to suit changing requirements. Programmable functions can be altered at any time.
  • Page 45: Programmable Functions

    – Indicator lights Machine iron and Hand iron = Machine iron+ B Press the I-On/0-Off button in. Wait until the indicator light for the Start/Stop button lights up constantly . . . C . . . and then release the Start/Stop button.
  • Page 46: Altering The Volume Of The Buzzer

    The buzzer sounds at the end of a Start/Stop button lights up programme (default setting). constantly . . . C . . . and then release the Start/Stop Loud The buzzer sounds at maximum volume button. at the end of a programme.
  • Page 47: Memory Function

    Start/Stop button lights up Delay start period selected will also constantly . . . be stored in memory. C . . . and then release the Start/Stop These settings will be selected button. automatically the next time the D Press the Low temperature button programme is chosen.
  • Page 48: Extending The Cooling Down Time

    Start/Stop button lights up makes the garments easier to constantly . . . handle. C . . . and then release the Start/Stop The cooling down time button. – can be extended by 5 minutes or 10 D Press the Low temperature button minutes.
  • Page 49: Clean Out Airways Indicator

    Start/Stop button lights up in the filters. You can decide at what constantly . . . level of fluff this reminder should be C . . . and then release the Start/Stop given. button. You will have an idea of which of the...
  • Page 50: Keypad Tone

    Start/Stop button lights up constantly . . . Before you begin, first ensure that: C . . . and then release the Start/Stop – The tumble dryer is switched off. button. – The door is closed.
  • Page 51: Adjusting The Dryer's Electronics For Very Soft Water

    If the machine is installed in an area constantly . . . with very soft water, you should contact your local water supplier for C . . . and then release the Start/Stop information and advice regarding button. water hardness and water D Press the Low temperature button six conductivity.
  • Page 52 Alteration rights reserved/1306 M.-Nr. 06 737 050 / 01 en - GB...

Table of Contents