Installing/Removing The Server In/From The Rack - Fujitsu PRIMERGY RX1330 M1 Operating Manual

5.2 Installing/removing the server in/from the
rack
V
CAUTION!
Please observe the safety information and notes on rack mounting in
●
chapter
installing the server in the rack" on page
At least two people are needed to install / remove the server in the
●
rack. (For the Japanese market, please refer to " 安全上のご注意 ".)
Do not extend more than one unit out of the rack simultaneously even
●
if the tilt protection is in place. If several units are simultaneously
extended out of the rack, there is a risk that the rack could tip over.
Fujitsu rack systems
The rack systems from Fujitsu support the installation of PRIMERGY servers:
– PRIMECENTER rack
– PRIMECENTER M1 rack
– DataCenter rack
– 19-inch standard rack (for the Japanese market)
– 19-inch slim rack (for the Japanese market)
I
For information on mounting the server in the rack please refer to the
Mounting Instructions provided with the Rack Mounting Kit. Further
information you find in the manual of your rack system.
For the Japanese market, please refer also to the "Rack system structure
guide".
I
Online documentation for rack installation can be found on:
http://manuals.ts.fujitsu.com/index.php?id=5406-5605-5606
(for the EMEA market)
http://jp.fujitsu.com/platform/server/primergy/manual/peri_rack.html
(for the Japanese market).
To accommodate the ventilation concept and ensure proper ventilation, any
unused areas in the rack must be sealed using dummy covers.
The power is supplied via the multiple socket outlets fitted in the rack (for the
EMEA market).
RX1330 M1
"Important information" on page 33
Operating Manual
Hardware installation
and section "Notes on
44.
49