To Recall Memory - Taylor The Biggest Loser Operating Instructions Manual

NOTE: This scale is programmed to measure all water based liquids. In practical terms
this covers almost every liquid used in domestic cookery including wine, milk, cream
etc.The exception is oil, which is not water based and would therefore not give such an
accurate measure (the error would be approx.+1 fl.oz at 10 fl.oz or + 50 ml at 500ml). If
your recipe shows liter or pint measures: 1 liter = 1000 ml, 1 pint = 20 fl.oz, 1/2 pint = 10
fl.oz, 1/4 pint = 5 fl.oz
:
TO WEIGH
1) Press and release the ON/OFF key to turn the scale on
2) Wait until display shows 0.0
3) Place item to be weighed on the platform
4) Weight is displayed
&
TO ADD WEIGH
To weigh several different ingredients, press the ZERO key to reset the display between each
ingredient.
NOTE: When weights have been tared out, the display will show a negative number when
the items are removed from the scale.To reset the scale back to zero for a new measurement,
press the ZERO button.
TO DISPLAY NUTRITIONAL READINGS
1) Press and release the ON/OFF key to turn the scale on
2) Place food item to be weighed on the platform.
3) Clear the food code if necessary by pressing and releasing the CLR key –
the food code 000 is displayed.
4) Refer to the table in this manual and identify the 3 digit code for the food item being
weighed (e.g. 755 for honey).
5) Using the numerical keys (0 – 9) enter the 3 digit code
6) When the 3rd digit is pressed, the values for calories, salt, protein, fat, carbohydrates,
cholesterol, and fiber for the food item will all appear on the screen.
TO SAVE NUTRITIONAL VALUES OF FOODS IN THE
DATABASE TO MEMORY:
1) Follow steps 1 – 6 of the 'To Display Nutritional Readings' section.
2) Press M+ key to add the food item being weighed to memory.
3) M01 will be shown at the upper left corner of the display to indicate that one set of
values has been saved to memory.To add additional food items to memory, repeat
the previous steps.
NOTE: The scale can only save foods in the existing database to memory. New foods cannot
be user-added.
NOTE:The memory is saved permanently, even if the scale is switched off except when the
batteries are removed.
NOTE:The maximum number of food items that can be added to the memory is 99.
When the memory number reaches 99 the display will flash "99" – the memory must be
cleared by following the instructions in the 'To Clear Memory' section.

TO RECALL MEMORY

1) Press MR key to see the total ingredients of the food items stored to memory.
2) Σ is displayed next to the memory indicator to indicate that the total memory is
being displayed.
3) The total values for calories, salt, protein, fat, carbohydrates, cholesterol, and fiber for
the food items stored in memory will all appear on the screen.
: It is not possible to display the total weight of the food items stored to memory.
NOTE
:
:
:
5