KT&C KM2115DKQCN User Manual page 191

 (SCAN): Press number Key and SCAN then the designated Scan will run.
(HOLD): Press HOLD to lock the Keyboard. To unlock user has to input Password. (Default password is 0000)

 : Press NEAR/FAR to adjust the focus of Speed Dome camera.
 : Press TELE/WIDE to adjust the zoom of Speed Dome camera.
NOTE
 SPD Control Mode is only supported when Speed Dome Camera is directly connected to CP1300.
WARNING
 Depending on the Protocol being used by the Speed Dome camera, controlling camera menu will differ. Please check
Speed Dome camera manual.
NOTE

When a Key does not Work after Set up
-
If the communication speed of DVR and CP are not co-related, it may not work. Please make sure the Baud rate of Keyboard sets on
9.6kbps.
-
Press the button to enter PTZ mode and switch to DVR mode again.
-
Please reboot the DVR.

When Tx Blinks Continually on the LED Window
-
If Tx blinks continually without any operation, it may be caused by improper set up of Joystick.
-
OFFSET of the Joystick may not appropriately set up.
-
Please do Joystick calibration.
191