Sharp VL-SW50U Service Manual page 40

vL-sw5ou
6-1-2-2. IC702 (E*PROM)
When the IC702 has been replaced, make the following settings and adjustments.
e System code setting
* Set the test mode to the VCR adjustment mode. Take the following steps.
1) Destination code Write the destination data (model numbers) to the addresses 02.
Destination 02
U 01
For calling the addresses and writing the data, refer to the VCR adjustment mode.
2) Specification switching code
Address Data
3) Menu selection code
Address Data
04 00
4) Softwere selection code
Address Data
05 00
5) Dew selection code
Address Data
3c cc
6) Function code
Address Data
03 F8
*After setting the above codes, clear the VCR adjustment mode and turn off the power.
Notes: Cope with only the following case (A), according as the following [Procedure].
(A) The case with the exception of "O", the superior bite [ ** h ] of date [Address : 021
-L
(B) [Procedure]
Superior bite
@ Set up "0" from the superior bite of date [Address : 021 : [ 0 *h 1.
-
Y- Set up "0"
@ Press "CONTINUE" key and set out the adjustment mode.
@ Disconnect the only battery of electric power on "switch-on".
Adjustments to follow
Make the system controller servo, VCR, and LCD adjustments according to their respective instructions.
6-1-2-3. Camera adjustment
All the camera adjustment data are written in the E2PROM provided on the lens unit. Therefore, when the lens is replaced,
the camera must be adjusted again according to the camera adjusting procedure.
6-l-3. Adjusting the Y/C, audio and LCD circuits on models without AA/ in mode
1)
2)
3)
(A/V in mode SET-UP produce)
Set the switch of main body to VCR, and use the remote control (RRMCG0033TASA) for adjustment to turn on the
adjustment mode.
Set up the adjustment address (example : EEmode adjustment address 14). Once this address has been set up, the A/V
IN mode (test mode) is automatically brought and the images appear on the LCD display.
Now make the adjustments referring to the instruotions in the manual.