Accessories; Technical Data; Rotating Laser Control Panel - Hilti PR 30-HVS Operating Instructions Manual

2.14 Battery charging activity is shown on the battery display while charging the battery outside the tool.
If the red LED lights constantly, the battery is being charged.
If the red charging activity LED does not light, then either the charging operation is complete or the charger is providing
no current.

3 Accessories

Designation
Laser receiver / remote control
Laser receiver
Laser receiver holder
Laser receiver holder
Height transfer device
Slope adapter
AC adapter
Car charging connector
Battery
Battery
Vertical angle
Batter board adapter
Batter board receiver holder
Facade adapter
Tripod
Crank tripod (elevator tripod)
Crank tripod (elevator tripod)
Automatic tripod
Telescopic staffs

4 Technical data

Right of technical changes reserved.
PR 30-HVS
Receiving range (diameter)
Range of remote control (circle diameter)
Accuracy 1
Plumb beam
Laser class
Speed of rotation
Slope range
Self-leveling range
1 Influences such as particularly high temperature fluctuations, dampness, shock, dropping, etc. can affect accuracy. Unless stated
otherwise, the tool was adjusted or calibrated under standard ambient conditions (MIL-STD-810G).
2 The drop test was carried out from a tripod, dropping onto flat concrete under standard ambient conditions (MIL-STD-810G).
Short designation
PRA 30 (03)
PRA 20 (02)
PRA 80
PRA 83
PRA 81
PRA 79
PUA 81
PUA 82
PRA 84
PRA 84G
PRA 770
PRA 750
PRA 751
PRA 760
PUA 20
PA 921
PUA 30
PRA 90
PUA 50, PUA 55
With PRA 30 (03) (typical): 2...500 m (6.56...1,640.42 ft)
With PRA 30 (03) (typical): 0...150 m (0...492.13 ft)
at 10 m: ± 0.75 mm
Continuous, perpendicular to the plane of rotation
Class 2, 620-690 nm; < 1 mW (EN 60825-1:2007 / IEC
60825-1:2007); Class II (CFR 21 § 1040 (FDA)); Maxi-
mum power < 4.85 mW at ≧ 300 r.p.m.
600/min, 1,000/min
With the tool pre-inclined: ≤ 21.3%
±5°
en
5