Table of Contents
Advertisement
Perform service, repairs and lubrication according to the maintenance section. Ensure the
unit is properly lubricated as specified in the lubrication schedule and all bolts and nuts are
properly torqued. Failure to properly service, repair and maintain this Implement in good
operating co ndition cou ld ca use co mponent failure and p ossible serious in jury or even
death.
Use cau tion a nd wear pro tective g loves w hen handling s harp o bjects suc h as blades,
knives, and other cutting edges. Be alert to worn component surfaces which have sharp
edges. Sharp surfaces can inflict severe laceration injuries if proper hand protection is not
worn.
Replace ben t o r b roken bla des with new bla des. NEVER A TTEMPT TO STRAIGHTEN,
WELD, OR WELD HARD FACING ON BLAD ES SINC E THIS WILL LIKEL Y CRACK OR
OTHERWISE DAMAGE THE BLADE
SERIOUS INJURY FROM THROWN BLADES.
DO NOT weld or repair rotating mower components. Welds and other repairs may cause
severe vibr ation an d/or co mponent failu re resulting in p art being th rown from th e mo wer
causing serious bodily injury. See your Authorized Dealer for proper repairs.
Alamo Industrial mowers use b alanced and matched system c omponents f or b lade carriers, b lades, c utter-
shafts, knives, knife hangers, rollers, drivetrain components, and bearings. These parts are made and tested
to Alamo Industrial s pecifications. Non-genuine "will fit" p arts do not consistently meet these specifications.
The use of "will fit" parts may reduce mower performance, void mower warranties, and present a safety haz-
ard. Use genuine Alamo Industrial mower parts for economy and safety.
Transporting Safety Instructions and Practices
Be particularly careful when transporting the Implement with the Tractor. Turn curves or go
up hills only at a low speed and using a grad ual steering angle. Rear mounted implements
move the center of gravity to the rear and remove weight from the front wheels. Make cer-
tain, by adding front ballast, that at least 20% of the tractor's weight is on the front wheels to
prevent r earing u p, loss o f s teering c ontrol or Tractor tip-over. Slow down on rough o r
uneven surfaces to prevent lo ss of steering control which could result in property damage
or possible injury. Do not transport unless 3-Point lift lever is fully raised and in the latched
transport position. Dropping implement in transport can cause serious damage to the trac-
tor and/or Implement and possibly cause the operator or others to be injured or killed.
Allow su fficient clea rance for th e Imple ment to swing outward while tu rning. Imple ments
carried behind the Tractor will swing outside the tire path when making turns. C ontacting a
solid object while turning will cause equipment damage and possible injury.
A-BOOM 03/09
© 2009 Alamo Group Inc.
SAFETY
(SG-35)
(SG-37)
PARTS INFORMATION
SEE YOUR ALAMO DEALER
Safety Section 1-14
WITH SUBSEQUENT F AILURE AND POS SIBLE
(SGM-10)
(SPRM-1)
(SGM-13)
(S3PT-02)
(S3PT-20)
Advertisement
Table of Contents
