Hardware Installation And Connection; Check Unpacked Nvr; About Front Panel And Rear Panel; After Remove The Chassis - ClearView PhoenixHP Quick Start Guid

1 Hardware Installation and Connection

Note: All the installation and operations here should conform to your local electric
safety rules.

1.1 Check Unpacked NVR

When you receive the NVR from the forwarding agent, please check whether there is any visible damage.
The protective materials used for the package of the NVR can protect most accidental clashes during
transportation. Then you can open the box to check the accessories.
Please check the items in accordance with the list (Remote control is optional). Finally you can remove the
protective film of the NVR.

1.2 About Front Panel and Rear Panel

The model label in the front panel is very important; please check according to your purchase order.
The label in the rear panel is very important too. Usually we need you to represent the serial number when
we provide the service after sales.

1.3 After Remove the Chassis

Please check the data cable, power cable, COM cable and main boar cable connection is secure or not.

1.4 HDD Installation

Important：
Please turn off the power before you replace the HDD.
The pictures listed below for reference only
You can refer to the User's Manual for recommended HDD brand. Please use HDD of 7200rpm or higher.
Usually we do not recommend the PC HDD.
1. Loosen the screws of the
upper cover and side panel.
4. Turn the device upside down
and then turn the screws in
firmly.
in the chassis.
2. Fix four screws in the HDD
(Turn just three rounds).
5.
Fix the HDD firmly.
3. Place the HDD in accordance with
the four holes in the bottom.
6. Connect the HDD cable and
power cable.
1