ntroductIon Getting Started Application • Review these instructions before beginning . They work with McQuay BACnet VAV Actuator 2508021 and 2508021P10 . These devices incorporate a solid state or 10K • Confirm that appropriate field wiring is installed (standard NTC sensing element to detect temperature . The effective six-conductor room sensor cables, plenum or non-plenum sensing and setpoint range is 55 to 95°F (13 to 35°C) .
nstallatIon nstallatIon The following section describes how to field install a new Installing a new BACnet VAV Actuator BACnet VAV Actuator Room Sensor . Expected Install Time: Room Sensor 20 minutes Mounting Information CAUTION Electrostatic discharge hazard. Can cause equipment Always mount the room sensor vertically, on a flat wall.
nstallatIon Electrical Box and Rough-in Mounting, Typical 2 . Drill two 3/16-inch (4 .8 mm) mounting holes and mount the two plastic wall anchors flush to below the wall CAUTION surface for stable mounting of the device . Over-tightening may cause the room sensor base plate to 3 .
Page 6
Daikin Applied Training and Development Now that you have made an investment in modern, efficient Daikin equipment, its care should be a high priority. For training information on all Daikin HVAC products, please visit us at www.DaikinApplied.com and click on Training, or call 540-248-9646 and ask for the Training Department.