Setting The Installation - Fujitsu LPF-4800 User Manual

Setting the INSTALLATION

You can adjust and select the following items from the INSTALLATION Menu.
INSTALLATION
Auto Power Up
Auto Lamp Off
Remote Control
Reverse Mode
: Select ENTER : Next
Auto Power Up
You can set whether or not the lamp comes on automatically when the
power plug is inserted in the socket.
Select by pressing the
The factory default setting is [Auto].
Auto Lamp Off
You can set whether or not the lamp goes off when there is no image
input signal for about 20 minutes.
Select by pressing the
The factory default setting is [On].
Remote Control
You can select use of the wireless remote control unit light receivers on
the front and rear of the projector from the following.
1) Rear & Front
The remote control signal can be received from the front and rear.
2) Rear
The remote control signal can be received from the rear only.
3) Front
The remote control signal can be received from the front only.
Select by pressing the
The factory default setting is [Rear & Front].
Reverse Mode
You can set vertical or horizontal inversion of the image from the
settings shown on the right.
Select by pressing the
The factory default setting is [Floor & Front].
En-28
Auto Manual
On Off
Rear & Front
Normal
and adjustment buttons.
and adjustment buttons.
and adjustment buttons.
and adjustment buttons.
Remote Control
Rear & Front
Rear
Front
: Select MENU : Return
(Remote Control)
Reverse Mode
Normal
H Invert
V Invert
H/V Invert
: Select MENU : Return
(Reverse Mode)