Pioneer AVH-P5700DVD Service Manual page 142

1
ADDRESS Bit15
34h
A
35h
36h
37h
38h
RELATED
TOUCH PANEL
39h
3Ah
3Bh
3Ch
3Dh
3Eh
3FH
Others
Addition 40H
B
41H
∼
To be
determined
7FH
*
The order of RELATED DIMMER, RELATED PIP, RELATED TOUCH PANEL and others is determined according to frequency of changing.
* When a writing & reading error or data check (checksum, magnitude relation) error occurs, initialization is done with data belonging to the software at the error time, and initialization is performed
per divided section described above.
However, RELATED DIMMER should be further divided into sections such as address 00H
*
The user changeable parts (address 00H
*
Concerning the segment RELATED DIMMER, considering PIP register configuration, data obtained from PIP can be stored without software processing.
And the alignment is designed to send data obtained from EEPROM to PIP without processing it. (same as NN629)
Each area is divided according as whether it is changed during operation or not. (Checksum division is carried out to each.)
*
Address 2H, remote control reverse output DC center value reference is not a target of checksum because it maintains default settings, and basically it is READ ONLY and is not shipped.
*
Address 40H, sampling phase reference is not a target of checksum because it maintains default settings, and basically it is READ ONLY and is not shipped.
*
At the time of EEPROM reset, the address above (excluding 2AH, 40H) is initialized with data belonging to the software.
*
A : Microcomputer writes the result whether flicker adjustment is performed or not (direct mode, EEPROM adjustment screen).
*
B : Production engineering jig: After completing EEPROM adjustment, the value is written (this value is displayed on the confirmation screen).
C
D
E
F
142
1
2
Bit14 Bit13 Bit12 Bit11
Touch panel X coordinate 10
Touch panel X coordinate 11
Touch panel X coordinate 12
Touch panel X coordinate 13
Touch panel X coordinate 14
Touch panel X coordinate 15
Touch panel X coordinate 16
Outermost circumference X min
Outermost circumference X max
Touch panel calibration adjustment result
Flicker adjustment completion EEPROM adjustment completion
(writing of microcomputer) A (writing of production engineering jig)
*
Don't care Ch sampling phase reference
∼
02H) in the segment RELATED DIMMER is not a target of checksum.
AVH-P5700DVD/EW
2
3
Bit10 Bit9 Bit8 Bit7 Bit6
Checksum
EEPROM address:2BH-3DH
B
*
Ch sampling phase reference
Don't care
Don't care
Don't care
∼ ∼
02H and 03H 04H, then initialized.
3
Bit5 Bit4 Bit3 Bit2
Touch panel Y coordinate 10
Touch panel Y coordinate 11
Touch panel Y coordinate 12
Touch panel Y coordinate 13
Touch panel Y coordinate 14
Touch panel Y coordinate 15
Touch panel Y coordinate 16
Outermost circumference Y min
Outermost circumference Y max
Touch panel outermost circumference adjustment result
EJECT lock value
Ch sampling phase reference
4
4
Bit1 Bit0