Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
●
Memory module/wireless module compartment cover (see
●
Hard drive (see
●
Keyboard (see
●
Top cover (see
To remove the power connector cable:
1.
Position the computer upright with the right side toward you.
2.
Disconnect the power connector cable (1) from the system board.
3.
Release the power connector cable from the clips (2) built into the base enclosure.
ENWW
Battery on page
39), and then remove the following components:
Hard drive on page
53)
Keyboard on page
58)
Top cover on page
61)
Spare part number
689678-001
WLAN module on page
48)
Component replacement procedures
73