Lincoln Electric RANGER SVM120-A Service Manual page 68

Lincoln electric welder user manual
Table of Contents

Advertisement

F-14
TROUBLESHOOTING GUIDE
PROBLEMS
(SYMPTOMS)
The engine goes to low idle but
does not stay in low idle.
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, con-
tact the Lincoln Electric Service Department for electrical troubleshooting assistance before you proceed. Call
216-383-2531 or 1-800-833-9353.
TROUBLESHOOTING & REPAIR
POSSIBLE AREAS OF
MISADJUSTMENT(S)
ENGINE PROBLEMS
1. Make sure there is NOT an
external load (auxiliary or weld)
connected to the RANGER 10-
LX.
CAUTION
RANGER 10-LX
Observe Safety Guidelines
detailed in the beginning of this manual.
RECOMMENDED
COURSE OF ACTION
1. The idler solenoid linkage may
be misadjusted or damaged.
2. The idler solenoid (L2) hold-in
circuitry may be faulty. Check
lead #214 for continuity (zero
ohms) from the solenoid to the
control board plug 5J1.
Wiring Diagram.
Ranger 10-LX in the low idle
mode, check for 10 to 12VDC
from lead #222F to lead #214.
If the correct DC voltage is pre-
sent, the idler solenoid (L2) may
be faulty. If the correct DC volt-
age is NOT present, the control
board may be faulty.
F-14
See
With the

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ranger 10-lx

Table of Contents