Sharp FACSIMILE FO-4500 Service Manual page 82

FO-4500H
16 Heater lamp
Fig. 16
1. Pull the Heater Lamp out of the lamp holder from the right side.
NOTE:
•
When reinstalling the Lamp, position its voltage indication on the
fusing drive gear side.
•
Be sure not to touch the lamp surface with bare hands.
2. Remove the harness cover.
3. Remove the fusing entrance guide.
4. Remove the Fusing Unit. (4 screws)
NOTE:
•
After reinstalling the Fusing Unit, check the direction of the bush-
ings on the Paper Exit Roller and the connection condition be-
tween the Roller and the ground plate.
3 – 25