Sharp FACSIMILE FO-4500 Service Manual page 8

FO-4500H
4
Remove the new drum cartridge from its packaging.
5
Align the arrowhead on the right side of the drum cartridge (the
right side is marked "R") with the arrowhead pointing down on the
right side of the compartment, and insert the cartridge into the
compartment so that the ends of the cartridge move along the
guides on the sides of the compartment. Make sure the cartridge
is set firmly in place.
•
Place the old drum cartridge (if you removed one) in the empty
drum cartridge bag, seal the bag, and dispose of it in a way that
conforms to any local regulations that may exist in your area.
•
If you are not replacing the toner cartridge, go to Step 7.
6
Remove the new toner cartridge from its packaging, and shake it
several times as shown.
•
This ensures that the toner is well distributed inside the car-
tridge.
7
Hold the handle of the toner cartridge so that the "2" marked on
the cartridge is to the right, and insert the cartridge into the com-
partment so that the two knobs on each side of the cartridge move
along the two guides on each side of the compartment.
Press the handle down so that the cartridge sets into place.
•
Place the old toner cartridge (if you removed one) in the empty
toner cartridge bag, seal the bag, and dispose of it in a way that
conforms to any local regulations that may exist in your area.
L
R1
Left
Right
2
Left
Right
1 – 6
8
Close the printer cover.
9
If you replace the toner cartridge, reset the toner counter by
pressing the LIFE key (flip up the Rapid Key overlay if necessary),
the "2" key, and the START key.
LIFE
V
F
If you replace the drum cartridge, reset the drum counter by
pressing the LIFE key (flip up the Rapid Key overlay if necessary),
the "3" key, and the START key.
LIFE
V
3. Assembly and connections
1
Insert one end of the telephone line into the socket on the fax
marked "TEL. LINE". Plug the other end into a new plan tele-
phone wall socket.
•
If you do not have a new plan telephone socket, contact your
local telephone supplier. Connection to the telephone network
must not be hard wired.
•
Eire: Only the supplied cord should be used. If a longer cord is
required, please consult your supplier or servicing agent.
START
2
START
3
TEL.
LINE