Bunker Hill Security 62368 Owner's Manual & Safety Instructions page 9

d. Check the Camera's signal strength.
Touch to check Camera 1.
note: Touch again to check other Camera(s).
good
excellent
Optimal acceptable
Figure H
Mounting to Solid Surface
1. Using a drill bit slightly smaller than the Screws,
drill pilot holes into the marked locations.
2. Position Mounting Bracket so that
mounting holes align with pilot holes.
3. Drive Screws through mounting holes in Base
and into pilot holes until the Mounting Bracket
is securely attached to the mounting surface.
Mounting to Hollow Surface
1. Using a drill bit slightly smaller than the
Anchors, drill holes in the marked locations.
2. Tap Anchors into the holes until they are
almost flush with mounting surface.
3. Position Mounting Bracket so that Mounting
Holes align with anchor holes.
Connect power
1. Connect the Power Adapter's cord
to the Camera's Power cord.
Item 62368
Low
needs
adjustment
adjustment
knob
Mounting
Bracket
Figure i
For technical questions, please call 1-888-866-5797.
3. Low signal adjustment:
a. Adjust the Camera and or/Receiver antenna(s).
b. Reposition the Camera and/or Receiver.
4. When the mounting location has been chosen:
a. Unplug the Power Adapter's
cord from the Camera.
b. Remove the Camera from the Mounting Bracket.
c. Using the Base as a template, mark
locations of mounting holes on
mounting surface. (See Figure i)
5. Repeat all steps with the other Camera(s).
4. Remove protective film from the Lens.
5. Attach Camera to Mounting Bracket, loosen
Adjustment Knob, adjust Camera as needed,
then tighten Adjustment Knob. (See Figure i)
4. Drive Screws through mounting holes in Base
and into anchor holes until the Mounting Bracket
is securely attached to the mounting surface.
5. Remove protective film from the Lens.
6. Attach Camera to Mounting Bracket, loosen
Adjustment Knob, adjust Camera as needed,
then tighten Adjustment Knob. (See Figure i)
Mounting
Holes
Base
2. Plug the Power Adapter into a 120VAC outlet.
Page 9