Case Front Controls - Lincoln Electric PRO DUAL POWER LN-25 Operator's Manual

B-4

CASE FRONT CONTROLS

Figure B.1
5 6
1 2 3 4 7 8 9 1 0 1 1
1
2
3
4
5
6
ITEM DESCRIPTION
1 Wire Feed Speed/Amperage Display
2 Wire Feed Speed LED
3 Amperage LED
4 Wire Feed Speed Knob
5 5 pin gun trigger connector
6 Work Clip Connection
7 Thermal LED
8 Voltage Display
9 Voltage LED
10 Set-up Push Button
11 Remote Voltage Control Knob
83% FUNCTIONALITY (for Innershield®
Pipeline welding)
With a special Gun, the LN-25™ Pro incorporates
83% functionality. This feature allows for the reduction
of the wire feed speed to 83% of the original set value
when activated with a second switch (usually in the
gun). The 100% wire feed is adjusted using the wire
feed speed knob on the front of the machine, and is
displayed on the right LED. When the reduced wire
speed switch (mounted on the gun handle) is in
Position No. 1, the wire speed feed will be that figure
indicated on the display. In Position No. 2, the wire
feed speed will be 83% of the figure indicated on the
display.
OPERATION
1. WIRE FEED SPEED/ AMPERAGE DIPLAY
2. WIRE FEED SPEED LED
7
(See displays in Item 1 for LED functions.)
3. AMPERAGE LED
8
(See displays in Item 1 for LED functions.)
4. WIRE FEED SPEED KNOB
9
(See displays in Item 1 for LED read out.)
10
5. 5-PIN GUN TRIGGER CONNECTOR
Control Cable plugs into from Gun and Cable
11
Assembly.
6. WORK CLIP CONNECTION
Connects to the work piece.
7. THERMAL LED
Thermal LED, Motor Overload The
thermal light illuminates when the wire
drive motor draws too much current. If
the thermal light illuminates, the wire
drive will automatically shutdown for up
to 30 seconds to allow the motor to cool. To start
welding again, release the gun trigger, inspect the
gun cable, liner (and conduit). Clean and make
repairs as necessary. Start welding again when
the problem has been safely resolved.
For best results, keep the gun cable and conduit as
straight as possible. Perform regular maintenance
and cleaning on the gun liner, conduit and gun.
Always use quality electrode, such as L-50 or L-56
from Lincoln Electric.
8. VOLTAGE DISPLAY
(See displays in Item 1 for Voltage functions)
9. VOLTAGE LED
(See displays in Item 1 for LED functions.)
10. SET-UP PUSH BUTTON
11. VOLTAGE KNOB
This knob allows you to control the power source
output arc voltage level.
LN-25™ PRO DUAL POWER
B-4