Technical Specification; Pack Contents - Valor COSYFLAME BR623 Installer's Manual

Hide thumbs Also See for COSYFLAME BR623:

Owner's manual (8 pages)

Table of Contents

An extractor fan may only be used in the same room as this appliance, or in any area from which ventilation for the appliance is

taken, if it does not affect the safe performance of the appliance. Note the spillage test requirements detailed further on in this

manual. If the fan is likely to affect the appliance, the appliance must not be installed unless the fan is permanently disconnected.

The appliance is fitted with an A.S.D (Atmosphere sensing device). If the appliance closes down after a period of operation for

no apparent reason, the consumer should be informed to stop using the appliance until the installation and appliance have been

thoroughly checked. The A.S.D will shut the appliance down if an unacceptable amount of harmful products of combustion

accumulate. Under no circumstances should the A.S.D be altered or bypassed in any way. Only a genuine Valor supplied

replacement part should be fitted. The individual A.S.D components are not replaceable.

Note that soft wall coverings (e.g. embossed vinyl, etc.) are easily affected by heat. They may scorch or become discoloured when

close to a heating appliance. Please bear this in mind when installing.

Propane gas appliances must not be installed in a room, which is built entirely below ground level (See BS 5871 Pt2).

Fire surround height:

Appliance depth:

Height of opening required:

Width of opening required:

Inlet Pressure

Input - Max. (Gross)

Input - Min. (Gross)

Output - Max.

Output - Min

Burner Test Pressure (Cold)

Gas Connection

Burner Injector

Pilot & Atmosphere Sensing

Device

Ignition

Aeration

When converted using Kit 591149

Clearance to combustible side panels:

The minimum height from the top surface of the hearth to the underside of any shelf made from wood or other combustible

materials is as follows: -

• For a shelf up to 150mm deep

Minimum height = 750mm.

• For a shelf deeper than 150mm

Minimum height = 750mm + 12.5mm for every 25mm depth over 150mm.

1 Hotbox and Burner assembly

1 Firefront Pack

1 Ceramics Pack

3 Self-Adhesive Foam seals

2 Tension Cables

2 Cable Adjusters