Speed Limiter - Skoda Fabia Operating Instructions Manual

Activate CCS (control deactivated)

Take control again / Increase speed
B a)

Start control / reduce speed
C

Switch between GRA and Speed Limiter
D

a)
If no speed is set the current speed is adopted.
At the start of the regulation the GRA regulates the vehicle to the current
speed, and this speed is shown on the instrument cluster display. The warning
light illuminates in the instrument cluster.

Automatic control interruption
Automatic control interruption occurs if any of the following conditions are
met.
›
The brake pedal is operated.
›
When one of the brake assist systems (e.g. ESC) intervenes.
›
Through an airbag deployment.
›
The key is actuated.
WARNING
Always deactivate the cruise control system after use to prevent the sys-
■
tem being enabled unintentionally.
Control may only be resumed if the set speed is not too high for the cur-
■
rent traffic conditions.
Note
During control, speed can be increased by pressing the accelerator pedal. Re-
■
leasing the accelerator pedal will cause the speed to drop again to the set
speed.
By pressing the  button during the regulation this is cancelled and the
■
Speed Limiter is activated.

Speed limiter


Introduction
This chapter contains information on the following subjects:
Operation
Operation description
The Speed Limiter limits the maximum driving speed to the set speed limit.
120
Driving
This limit can only be exceeded by depressing the accelerator pedal fully.
The condition in which the Speed Limiter monitors a potential set speed limit
excess is referred to as Regulation.
» page 120
Operation
120
121
WARNING
The speed limiter only serves as an assistance and does not relieve the
■
driver of the responsibility for the vehicle operation.
Always adjust the speed and driving style to the current visibility, weath-
■
er, road and traffic conditions.
Fig. 132 Maxi DOT display: Examples of Speed Limiter status displays
