Skoda Fabia Operating Instructions Manual page 124

Hide thumbs Also See for Fabia:
Table of Contents

Advertisement

Fig. 133 Segment display: Examples of Speed Limiter status displays
Read and observe
on page 120 first.
Status display of the Speed
Limiter» Fig.
Speed limit set, but regulation is inactive.
Control is active.
No speed limit set.
System fault - seek assistance from a specialist garage immediately.
Basic requirements for starting the control
The Speed Limiter is activated.
The current speed is higher than approx. 30 km/h.
Operation description
Fig. 134 Operating elements of the speed limiter: Vehicle with Speed Lim-
iter / vehicle with GRA and Speed Limiter
132,
» Fig. 133
Read and observe
on page 120 first.
Overview of the control elements of the Speed Limiter
Speed Limiter disable (set limit delete)
A

Interrupt control (sprung position)

Activate Speed Limiter (regulation deactivated)

For vehicles with GRA and Speed Limiter, the GRA is activated by
the switch in the  position by being adjusted. The activation of
the Speed Limiter occurs only after pressing the button .
Take control again
/ Increase speed - short press (in increments
B
a)

of 1 km/h), long press (in increments of 10 km/h)
Start regulation / reduce speed - short press (in increments of 1
C

km/h), long press (in increments of 10 km/h)
Switch between GRA
D

a)
If no speed limit is set, the current speed is set as the speed limit.
At the start of the regulation, the current speed is set as the speed limit and
displayed in the instrument cluster display. The warning light
the instrument cluster.
Exceeding the speed limit during the regulation
If exceeding the speed limit is required during the regulation, for example
when overtaking, then the accelerator pedal is to be fully pressed.
When exceeding the speed limit, an acoustic signal sounds and the warning
light in the instrument cluster flashes.
The regulation is resumed once the speed has fallen below the set limit.
CAUTION
When driving downhill, exceeding the set speed limit may occur. When exceed-
ing the limit, an acoustic signal sounds and the warning light in the instru-
ment cluster flashes.
Note
By pressing the  button during the regulation this is cancelled and the GRA
is activated.
» Fig. 134
» page 118
and Speed Limiter
illuminates in
Assist systems
121

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents