Starting The Engine - Victory 2007 VEGAS Owner's Manual

Engine Break-in Period

Starting the Engine

The VICTORY motorcycle has a starter interlock system. The engine can be started only when the transmission is
in neutral or when the transmission is in gear and the clutch is disengaged (clutch lever is pulled in).
Follow these steps to start the motorcycle:
1. Perform the Pre-Operation Check as outlined beginning on page 51. If you're carrying cargo, inspect the cargo
restraints for tightness.
2. Insert the ignition key into the ignition switch and turn the switch to the ON position (see page 38).
3. Mount the motorcycle and bring it to an upright position. Engage the front brake and place the sidestand in the
stored (up) position. If the neutral indicator is not illuminated, shift the transmission to neutral (see Shifting
Gears, page 71).
4. If the engine is cold (has not been run in a few hours) move the fast idle lever toward the rear of the motorcycle
until the lever stops.
5. Set the engine stop/run switch to the RUN position. You should hear the fuel pump run momentarily as it
pressurizes the fuel system. NOTE: If the motorcycle was run completely out of fuel, prime the system as
instructed on page 68.
OPERATION
69