Page 1
Parts and Instruction Manual EX12 Carpet Extractor...
Page 2
This manual is furnished with each new MINUTEMAN EX12 . This provides the necessary operating and preventive maintenance instructions. Operators must read and understand this manual before op- erating or servicing this machine. This machine was designed to give you excellent performance and efficiency. For best results and minimal cost, please follow the general guidelines below: ·...
Safety Precautions This machine is intended for commercial use. It is 4. Before leaving or servicing machine: designed to clean carpet and upholstery in an indoor -Turn off machine. environment and is not constructed for any other -Unplug cord from wall outlet. use.
Safety Labels The safety labels appear on the machine in various locations. Replace labels if they become damaged or cannot be read. WARNING: Flammable materials can cause an explosion or fire. Do not use flammable materials in tank(s). Flammable materials or reactive metals can cause explosion or fire.
Machine Set Up Pre-Operation 1. Vacuum carpet and remove other debris. 7. Connect solution hose and make sure it is firmly secured. 2. Perform MACHINE SETUP procedures. 3. Inspect power cord for damage. 8. Turning machine on: Set Up A. Turn pump switch on. 1.
Operation Maintenance DAILY: WARNING: Flammable materials or reactive metals can cause an explosion or fire. 1. Empty and rinse out solution tank thoroughly. Do not pick up. 2. Wipe off power cord and check for damage, replace if 1. Work away from outlet and power cord to necessary.
Storing Machine 1. Before storing machine, be certain to completely drain rinse tanks of all water and solution. 2. Drain and dry the vacuum hose as well, using the drain hose provided 3. Store machine in a dry area in the upright position. 4.
Page 9
SYMPTOM: HEATER IS NOT WORKING PROPERLY: PROBLEM: The back up sensor, mounted on the heater has popped. SOLUTION: Reset sensor by pushing in button. PROBLEM: Heating element is bad. SOLUTION: Replace element. SYMPTOM: VACUUM MOTOR IS NOT WORKING PROPERLY: PROBLEM: Hose not connected tightly to upholstery tool or machine.
EX12 - Bill Of Materials Bill Of Material - EX12 Item Part No. Qty. Description Item Part No. Qty. Description 121052 cap, axle, 1/2" 121155 bolt, 1/4-20 x 1-1/4" hex head 121059 wheel, 12" 121119 Bracket, L 070-036 121167 washer, axle, cut 1/2" id...
EX12H - Bill Of Materials BILL OF MATERIAL - EX12H ITEM PART NO. QTY. DESCRIPTION ITEM PART NO. QTY. DESCRIPTION 121163 NUT-LOCK 1/2" STEEL 121125 3 SUPPORT-VAC 3 STAGE 4-1/16" 121053 FITTING-STRAIN RELIEF CORD 121182 9 BOLT-SERRATED 1/4-20 X 1/2" 121032 CORD-POWER END 25' GRY 121021...
A potential health hazard exits without original equipment replacement. All warranted items become the sole property of Minuteman or its original manufacturer, whichever the case may be. Minuteman disclaims any implied warranty, including the warranty of merchantability and the warranty of fitness for a particular purpose.
Need help?
Do you have a question about the EX12 and is the answer not in the manual?
Questions and answers