Panasonic VieraLink SC-ALL30T Operating Instructions Manual page 30

Sound
No sound (or image).
≥ Turn muting off. (
≥ Check the connections to the other devices.
( 8 - 10)
≥ Make sure that the received audio signal is
compatible with this system. (
≥ Turn this system off and then on again.
≥ If the main unit is connected to the TV with
only an HDMI cable, make sure that the TV's
HDMI terminal is labelled "HDMI (ARC)". If
not, connect using the optical digital audio
cable. ( 8, 9)
≥ If the main unit is connected to a Panasonic
TV and turned on using the remote control or
the touch key on the main unit, sound might
not be output from this system. In this case,
turn the main unit on using the TV's remote
control. ( 27)
≥ If the connections are correct, there might be
a problem with the cables. Redo the
connections with different cables.
≥ Check the audio output settings on the
connected device.
The dual audio cannot be changed from
main to secondary.
If the audio received from the connected device
is not "Dolby Dual Mono" or the output setting is
not "Bitstream", the setting cannot be changed
from this system. Change the setting on the
connected device.
The volume is lowered when the main unit is
turned on.
"VOL LIMITATION" is on.
If the main unit is turned off with the volume
setting in the greater half (above 50), the main
unit will automatically lower the volume to the
middle (50) when the main unit is turned on.
( 23)
The dialogue is too persistent or the
dialogue does not sound natural.
This system has a function to make the dialogue
stand out when the volume is low. (
30
SQT0936
16)
35)
22)
The sound lags behind the image.
Depending on the TV, when this unit is
connected to it via Bluetooth
from this unit may lag behind the TV image.
Connect this unit and the TV with an HDMI
cable/optical digital audio cable. (
Sound stops.
The power of the main unit turns off
automatically.
(When the main unit detects a problem, a safety
measure is activated and the main unit
automatically switches to standby mode.)
≥ There is a problem with the amplifier.
≥ Is the volume extremely high?
If so, lower the volume.
≥ Is this system placed in an extremely hot
place?
If so, move this system to a cooler place and
wait a few moments and then try to turn it on
again.
If the problem persists, confirm the display, turn
this system off, remove the AC mains lead cord
and consult your dealer. Please be sure to
remember the display that was indicated and
inform the dealer.
Network
Cannot connect to the network.
≥ This system's Wi-Fi security supports WPA2
only. Your wireless router must therefore be
WPA2 compatible. For details on the
TM
security supported by your router and how to
change the settings, please refer to the
operating instructions or contact your Internet
service provider.
≥ If the network is set to be invisible, make the
network visible while you set up the network
for this system or make a wired LAN
connection. ( 15)
≥ Make sure that the multicast function on the
wireless router is enabled.
≥ Depending on the routers, WPS button may
not work. Try other methods. (
, the sound output
®
8, 9)
TM
12)