Panasonic VieraLink SC-ALL30T Operating Instructions Manual page 29

≥ When the HDMI connections are changed,
after a power failure or after the AC mains
lead has been removed, VIERA Link
operations may not function properly.
jTurn on all the devices that are connected to
the TV with an HDMI cable and then turn the
TV on.
jTurn off the VIERA Link settings of the TV
and turn it on again. For details refer to the
operating instructions for the TV.
jWhile the main unit and the TV are
connected with the HDMI cable, turn on the
TV and then remove the main unit's AC
mains lead and reconnect it again.
The first few seconds of audio cannot be
heard when using the HDMI connection.
This may occur during DVD-Video chapter
playback. Change the digital audio output
setting on the connected device from
"Bitstream" to "PCM".
When operating an HDMI compatible device
of a different brand, the main unit reacts in
an unwanted manner.
HDAVI Control commands may use a different
signal depending on the brand of the device. In
this case, turn VIERA Link off. (
When the main unit is turned on or off, audio
and video are temporarily disabled.
When the main unit is turned on or off it is
normal for the audio and video to be temporarily
disabled. This is not a malfunction. This can
occur when the device it is connected to, via
HDMI, does not support Panasonic's VIERA
Link feature (HDAVI Control 3 or later).
The images from this system do not appear
on the TV.
When outputting in 60p (4K), images may be
distorted depending on the HDMI cable. Use
High Speed HDMI cables which support
18 Gbps bandwidth.
Pairing cannot be done.
Check the Bluetooth
The device cannot be connected.
≥ The pairing of the device was unsuccessful or
the registration has been replaced. Try pairing
the device again. (
≥ This system might be connected to a different
device. Disconnect the other device and try
pairing the device again.
The device is connected but audio cannot be
heard through this system.
For some Bluetooth
the audio output to "SC-ALL30T" manually.
Read the operating instructions for the device
for details.
Connection is interrupted.
Sound is interrupted/sound skips/there is a
lot of noise.
≥ Remove any obstacle between the main unit
and the device.
≥ Other devices that use the 2.4 GHz frequency
23)
band (wireless router, microwaves, cordless
phones, etc.) are interfering. Bring the
Bluetooth
distance it from the other devices.
≥ Select "MODE 1" for stable communication.
(
If the above does not fix the problem, you may
be able to fix the problem by reconnecting this
unit and the Bluetooth
The One-Touch Connection (NFC feature) is
not working.
≥ Make sure the main unit and the NFC feature
of the device are turned on. (
≥ Change the touch location of the Bluetooth
device or main unit and then touch the NFC
touch area again.
Bluetooth
®
device condition.
®
19)
devices, you have to set
®
device closer to the main unit and
®
23)
device.(
®
20)
20)
®
29
SQT0936