Using This System - Panasonic VieraLink SC-ALL30T Operating Instructions Manual

Using this system

Operations
Preparation
≥ Turn on the TV and/or connected device.
1
2
INPUT
SETUP
1 Press [Í] to turn on the main unit.
2 Select the source.
Press
"TV"# "BD/DVD"# "AUX"
≥ When switching the source to
[INPUT]
Select the Bluetooth
[ -PAIRING] device as the source.
(
≥ This remote control cannot be used to control the
operations of the connected devices.
∫ When "BD/DVD" or "AUX" is
selected as the source
On the TV and the connected device:
Select the TV's input for this system and start
the playback on the connected device.
∫ When "BLUETOOTH" is selected as
the source
On the Bluetooth device:
®
Select this system as the output source of the
connected Bluetooth
®
playback.
16
SQT0936
SOUND
 OK

To select
^----"BLUETOOTH"(-}
"BLUETOOTH" and then to
"TV" in succession, after
switching it to "BLUETOOTH",
wait for a while, and press
[INPUT].
®
19, 20)
device and start the
∫ To adjust the volume of this system
Press [j VOL i].
≥ Volume range: 0 to 100
∫ To mute the sound
Press [MUTE].
≥ While muting, "MUTE" is indicated on the display.
≥ To cancel, press the button again or adjust the volume.
≥ Muting is cancelled if the main unit is turned off.
If this system does not operate as
expected or sound is unusual, returning
the settings to the factory preset may
solve the problem. (
≥ If there is sound coming out of the TV's speakers, reduce
the volume of the TV to its minimum.
≥ There may be a difference in the maximum volume value
of the TV and the unit.
≥ When playing equipment connected to the HDMI AV IN
terminal, to switch audio/video to the TV, switch input to
the TV tuner. If VIERA Link (HDMI) (
enabled, also switch the input of this unit to TV.
Remote control code
When other Panasonic devices respond to this
system's remote control, change the remote
control code on this system and the remote
control.
Preparation
≥ Turn off all other Panasonic products.
≥ Turn on the main unit.
≥ Aim the remote control at this unit's remote
control sensor.
∫ To set the code to "REMOTE 2"
While pressing and holding [MUTE], press
and hold [OK] for 4 or more seconds.
"REMOTE 2" is indicated on the display.
∫ To set the code to "REMOTE 1"
While pressing and holding [MUTE], press
and hold [4] for 4 or more seconds.
"REMOTE 1" is indicated on the display.
28)
26) is not