Lincoln Electric LN-15 WIRE FEEDER SVM166-A Service Manual page 11

A-5
CONNECTION DIAGRAM, ACROSS THE ARC MODEL Set-Up
Typically used for general fabrication, maintenance and repair jobs because it's easy to set up and operate.
Requires only one cable-less to carry. Contactor standard on Across The Arc Model.
RANGER 8
SAE 400 WITH CV ADAPTER
ENGINE DRIVEN WELDERS
WITH WIRE FEED MODULE
(LOCAL MODE AND CV ADAPTER)
CV250
CV300
CV400
CV655, DC400, DC600,
DC655, V350-PRO,
RANGER 9, RANGER 300 DLX
COMMANDER 300
COMMANDER 500
RANGER 250
RANGER 305G
CC POWER SOURCE
Although a constant voltage (CV) power source is recommended for best results with Innershield® and gas metal
arc (GMAW) open arc welding, satisfactory general purpose welding may be obtained using the LN-15 with a con-
stant current (CC) power source for non-critical commercial quality mild steel welding applications.
INSTALLATION
FIGURE A.1
semiautomatic
Output Output Terminals erminals
Always Hot.
Electrode Cable
Output Terminals Output erminals
Always Hot.
Order K484 Jumper Order K484 Jumper
Plug Kit.
Electrode Cable
Output Output Terminals erminals
Always Hot. Always Hot.
Power source contactor Power source contactor
switch must be in the switch must be in the
"ON" position or use a "ON" position or use a
K848 Junper Plug Kit.
Electrode Cable
Output Terminals erminals
Output
Always Hot. Always Hot.
Electrode Cable
LN-15
( See Figure A.1)
semiautomatic
wire feeder
wire feeder wire feeder
K1870-1
K1870-1 K1870-1
semiautomatic
wire feeder
K1870-1
semiautomatic
wire feeder
K1870-1
A-5
Work
Clamp
Work
Clamp
Work
Clamp
Work
Clamp