Using The Stealth Sp-1 With A Stealth Dc-1 - Emotiva Stealth SP-1 User Manual

Stealth SP-1 Input Selector and Phono Preamp

Using The Stealth SP-1 With a Stealth DC-1

The Stealth SP-1 is designed primarily to be used in conjunction with the Stealth
DC-1. Together, the SP-1 and DC-1 comprise a powerful and flexible preamp with both
line level and phono analog inputs and a full complement of digital audio inputs.
Connections
When the Stealth SP-1 is used with the DC-1, a single set of short stereo interconnects
is placed between the outputs on the SP-1 and the Analog Inputs on the DC-1.
Operation
All analog sources will now be connected to the SP-1, and will be controlled by the
SP-1, while digital sources will be connected directly to the digital inputs on the DC-1.
When used in this mode, the DC-1 remote control will control both units, and the rear
panel Power switches on the SP-1 and DC-1 should be left in the On position.
When the On button on the DC-1 remote control is pressed, both the DC-1 and the
SP-1 will turn On and, when the Off button is pressed, both units will turn Off.
All digital inputs are selected as you normally would using the DC-1's remote control.
To select any analog source connected to the SP-1, you will press the Analog source
button on the DC-1's remote control, which will select the SP-1 as your source. After
the SP-1 is selected, pressing the Analog button on the DC-1 remote control will then
cycle through the available analog inputs on the SP-1. To switch back to a digital input
on the DC-1, simply press the appropriate input selector button for one of the digital
inputs on the remote control.
Page 11