Stealth Sp-1 (Front Panel) - Emotiva Stealth SP-1 User Manual

Stealth SP-1 Input Selector and Phono Preamp

Stealth SP-1 (Front Panel)

1
2
1. Standby button
Press this button once to turn the SP-1 On, press it again to turn the SP-1 Off.
Note: The SP-1 can only be turned On using the Standby button if the Power
switch on the rear panel is On.
2. Input Selector buttons
Press one of these buttons to select an input, which is then routed to the output. The
halo ring around the selected input will blue.
Input 1 through Input 3 are entirely passive line level analog inputs switched by
precision relays, and so add virtually no noise or distortion to the signal. The Phono
input button selects the SP-1's high performance internal phono preamp.
Note: Only one input may be selected at once. When you select an input, any
previously selected inputs will be deselected.
Note: The SP-1 remembers which input is selected when you power it down
and automatically selects the same input the next time you turn it On.
Page 7