Stealth Sp-1 (Rear Panel) - Emotiva Stealth SP-1 User Manual

Stealth SP-1 Input Selector and Phono Preamp

Stealth SP-1 (Rear Panel)

1
OUTPUT
MC MM
L
MC MM
GND
R
3 4
1. Phono Cartridge Type switches
These switches match the gain of the phono preamp in the SP-1 to the output level
of your phono cartridge. If your phono cartridge is a moving coil type, then set these
switches both to the left (MC); if your phono cartridge is a moving magnet type, then
set both switches to the right (MM).
Note: Both switches should be set to either MC or MM.
Note: Some high-output moving coil cartridges are specifically designed to be
used with the gain of your phono preamp set to the MM position.
2. Main AC Power switch
This switch controls the main AC power to the Stealth SP-1. Turning this switch On
places the SP-1 into Standby mode; turning it off switches the SP-1 Off. This switch
must be in the On position before you can turn the SP-1 On using the front panel
Standby button.
3. Stereo Analog Outputs
The signal at the selected input on the SP-1 is routed to this output. Input signals from
Input 1, Input 2, and Input 3 are routed directly to the output via relays, which add
virtually no noise or distortion. The signal received at the Phono Input is amplified and
equalized by the SP-1's precision phono preamp, then sent to the output.
Note: Switching for the line level inputs on the SP-1 is via precision control
relays; the signal path is entirely passive, no buffering or gain is applied, and
no distortion or noise is added to the signal.
L L
PHONO
R R
5
ANALOG INPUT
L L
3 2
R R
6
Page 8
2
1
7
POWER