Safety Precautions; Operating The Scale - Acom AC-100 Owner's Manual

Safety Precautions

!
Place the scale on a flat and rigid surface
!
Place the scale far from strong RF interference
!
Level the scale using its adjustable feet
!
Do not subject the platter to sudden impacts
!
Do not spill the water or any other liquid on the scale
!
Do not use any solvents to clean the scale
!
Do not remove the safety ground on the power cord

Operating the Scale

Make sure the platter is sitting properly on top of the platform and that
there is nothing on top of the platter. Also, make sure that the scale is
plugged into the proper outlet. Place the power switch into the ON
position. The scale displays will run through a self test, count down to
zero, and then beep. All of your displays should look as follows:
The number of significant digits on the weight display may vary
depending on the scale's capacity and the current weighing unit being
displayed.
Manual Tare Entry
1. Make sure the Zero and Stable Lamps are on.
2. Select the weighing unit you wish to use by pressing the WEIGHT
CONV. Key.
3. Type the tare weight of the item that you wish to tare. Do not use
the decimal point key as the scale will always automatically
insert the decimal point.
4. Press the TARE key.
0.00 0
0
6