Acom AC-100 Owner's Manual page 10

Counting by Using PLUs
1. Make sure the Zero and Stable Lamps are on.
2. Place the parts that you wish to count on the platter.
3. Enter the PLU number of the part that you wish to count. PLU
numbers range from 0 to 199.
4. Make sure that the Stable Lamp is on.
5. Press the !M key.
Steps 2 & 3 can be interchanged. The scale will now display a unit
weight and a count. The scale may also flash the Ls or Lu Lamps
depending on certain criteria specified on page 4. You can begin
counting.
Using the ADD Function
1. Get into counting mode by using any of the 3 ways of counting
(counting by unit weight, sample, or PLU.)
2. Place the batch of parts that you wish to add onto the platter.
3. Make sure that the Stable Lamp is on.
4. Press the ADD key. The displays will show:
5. The Count display above shows 500 as an example.
The number in the Count Display represents the Running Total
Count.
The Number in the Unit Weight display shows the number of
times batches have been added to the Running Total Count.
6. Remove the batch of parts that have just been added.
7. If there is another batch of parts you wish to add go to step 2
otherwise continue on to step 8.
8. Press the SUM key. The displays will show:
Add
totAL
1
500
10
5000
8