Safety Precautions; Operating The Balance - Acom JW-1 Owner's Manual

Safety Precautions

Place the balance on a flat and rigid surface
Place the balance far from strong RF interference
Level the balance using its adjustable feet
Do not subject the platter to sudden impacts
Do not spill the water or any other liquid on the balance
Do not use any solvents to clean the balance
Do not leave the balance in direct sunlight

Operating the Balance

Make sure the platter is sitting properly on top of the platform and that
there is nothing on top of the platter. Also, make sure that the balance
is plugged into the proper outlet. Place the power switch into the ON
position. The display will run through a self test and then go to zero.
The balance will always remain in the last mode that it was left in. The
display may appear as follows (remember that the decimal place and
number of zeros may differ depending on what mode the balance was
last set to and what the balance's capacity is:)
This example is the JW-1 300g in lb mode. If all
precautions are followed properly, you will see this
display along with the ZERO and STABLE lamps and the lb enunciator.
Changing Modes
You can toggle through each of the 10 modes by pressing the MODE
key. If you start with pound mode (lb) then the mode key will toggle as
follows:
lb dwt GN
As the display toggles between the different modes the decimal place
and number of zeros may differ depending on the mode and what the
balance's capacity is. For more details see the Weigh Range Chart at
the end of this manual.
kg toz g
0.00000
pcs % ct oz
5