Safety Precautions; Operating The Scale - Acom SI-1 Owner's Manual

Safety Precautions

!
Place the scale on a flat and rigid surface
!
Place the scale far from strong RF interference
!
Level the scale using its adjustable feet
!
Do not subject the platter to sudden impacts
!
Do not spill the water or any other liquid on the scale
!
Do not use any solvents to clean the scale
! Do not leave the scale in direct sunlight

Operating the Scale

Make sure the platter is sitting properly on top of the platform and that
there is nothing on top of the platter. Also, make sure that the scale is
plugged into the proper outlet. Place the power switch into the ON
position. The display will run through a self test and then go to zero.
The scale will always remain in the last mode that it was left in. The
display may appear as follows (it will read 0.0 if it is a 300 lb scale:)
!
Zero Stable
Changing Modes
You can toggle through each of the 4 modes by pressing the MODE
key. If you start with pound mode (lb) then the MODE key will toggle
as follows:
4
!
Net pcs
lb " " kg " " Count "
" " " "
0.00
!
lb kg
" Limit
" "