Options & Accessories; Troubleshooting & Error Messages - Acom AC-100 Owner's Manual

The Number in the Count display represents the high limit for
Limit Counting. When you are counting:
if the Current Count > High then the Limit Lamp will flash and
the scale will continuously beep.
4. Enter the high limit using the numeric keys. If you do not want a
high limit press the C key.
5. Press the SET key.
To disable the use of Limit Mode simply enter 0 as the low limit and 0
as the high limit.
Options & Accessories
The following options are available through your ACOM Authorized
dealer:
Description
Spill-Proof Overlay (Wet cover)
Adjusting feet (set of 4)
For any type of service or troubleshooting, please contact your nearest
ACOM Authorized dealer.
disassemble this or any scale as this is legally permissible to only
licensed professionals.
Troubleshooting & Error Messages
Error
Zero Initial zero range error
AdC Analog circuit failure
EEP Memory failure
PArA Parameter failure
For more information go to:
http://www.acomamerica.com/techs.htm#AC-100%20Techs
AC Power cord
DO NOT attempt to service , repair, or
Description
Part Number
101-00001-020000
690-00001-02002M
4B0-00001-020000
Solution
Empty the platter, turn OFF and ON.
If this occurs again then call service
Call service
Call service
Call service
12