Table of Contents
Advertisement
Operating on AC Power
Using an optional AC-DN10 AC adaptor, you can operate
the transmitter on AC power.
When using an AC adaptor
Connect the transmitter to the AC power supply through
the AC Adaptor as shown below.
DC IN
DC output cable
When using the AC-DN10 AC adaptor
Mount the AC-DN10 on the Camcorder just as you would
a battery pack, then connect to the AC power supply.
The AC-DN10 can supply power up to 100 W.
AC power cord
(suppled with
AC-DN10)
Cord cramper
AC outlet
Note
Do not use the AC-DN1, which can supply only small
power.
AC Adaptor
AC outlet
DC OUT
AC-DN10
Menu Settings
You can perform various settings using menus on the
display.
The menu settings are maintained even if you turn the unit
off.
Menu Items
Wireless menu
Menu
Submenu
Values (default)
Freq
—
CH1–CH7 (CH4)
Freq
—
2406–2478 MHz (2442 MHz)
RF Power
—
High, Low (Low)
Mode
—
Standard, Robust, HiPicture
(Standard)
Interleave
—
Fast, Run, Walk, OFF(Fast)
Emission
—
OFDM, CW, OFF (OFDM)
Scramble
Scramble
*** (AAA)
Freq: Set the transmission frequency by the channel. The
frequency can be selected in 12-MHz steps.
CH1: 2406 MHz
CH2: 2418 MHz
CH3: 2430 MHz
CH4: 2442 MHz
CH5: 2454 MHz
CH6: 2466 MHz
CH7: 2478 MHz
Set the WLL-RX50/RX55 receiver to be used in
combination to the same channel.
If you select "Freq" and set a frequency that does not
coincide with any of the CH1 to CH7 frequencies, the
channel column shows "CH-".
Freq: Set the transmission frequency.
It can be selected in 1-MHz steps.
Set the WLL-RX50/RX55 receiver to be used in
combination to the same frequency.
RF Power: Select the RF output.
High: For long-distance transmission
Low: For short distance less than 10 meters
Mode: Select the transmission mode.
Standard: Standard mode
Robust: Mode for more stable transmission.
The picture quality is degraded when compared
with Standard mode.
HiPicture: Mode for transmission with higher picture
quality. The stability is decreased when compared
with Standard mode.
Interleave: Select the time interleave mode.
No data permutation is performed if this is set to OFF.
15
Menu Settings
Advertisement
Table of Contents
